Sonic Modell - AR Wing Classic 900mm
An FPV wing had been on my to-do list for a long time. Since I didn't want to buy all new components to try it out, it made sense to use many components from the 5" drone sector. The AR-Wing from Sonic Modell was the perfect model for this. The flight controller from the drone range can be operated with INAV and offers sufficient UARTS, as well as servo and motor connections. With the 6S 1300mAh battery used, flight times of 10 minutes are easily possible. The maximum speed is around 170 km/h, although the ESC gets very hot at full throttle. I converted the voltage regulator for VTX and CAM on the FC to 6,0V by resizing the feedback resistors and use it as a BEC for the two servos. I cut away the originally intended FPV CAM holder and glued a self-printed CAM adapter into the Action CAM mount. I currently have an HDZero Whoop Lite VTX with an HDZero Micro V2 CAM installed, but this will soon be replaced with a DJI O4 Lite (Flywoo Wide Lense makes the FOV perfect ;-)).
Setup:
| Flight Controller | JHEMCU - F405 NOXE V2 (INAV Target: JHEMCUF405) |
| ELRS Receiver | BetaFPV - SuperD |
| ESC | Holybro - Tekko 32 35A - BL-Heli32 with ESC-Temetry |
| FPV System | HDZero Whoop Lite VTX and HDZero Micro V2 CAM |
| Servo BEC | JHEMCU - F405 NOXE V2 - VTX supply (10V converted to 6V) |
| Servos | Hitec - HS-5065MG ( i still had some of these, but some cheaper ones would also do the job ) |
| GPS | Walksnail - WS-M181 M10 GPS (compass is not used) |
| Motor | EMAX - Eco II 2306 1900KV |
| Propeller | Azure - 5145 Vanover |
| Battery | Tattu - 6S1300 |